Office Equipment in South Rand [Category: Delete all the printer drivers presented in the list. Page Lower the printhead lock cover toward you to lock the printhead in place. Equipped with the nozzles that supply the inks for printing. No Media Problem 1:
|Date Added:||28 September 2007|
|File Size:||27.65 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Hold the roll media near the left and right side of the leading edge, then insert it. The printer has malfunctioned.
A2 Size and smaller Set the weight roll inside the slack of the roll media. Illustrations And Screen Examples Illustrations and Screen Examples The illustrations and screen examples used in this guide were created with the W but they also apply to the W The W provides full network support for PC and Mac platforms via its multi-interface. If the printer is off, press the Power button to switch the printer on.
Page 58 Insert the media core onto the center hubs of the take-up holders. High Quality Printing On Film High Quality Printing on Film By adjusting the height of the printhead before printing on glossy film or other film base media, you can achieve superior quality image printing. Interface Required Connector Cznon. This could lead to ink clogging in the tank and poor printing.
Page of Go. Obtaining the Firmware Update Contact a Canon service center, or the dealer where you purchased the printer, for details about how to obtain the most recent version of the firmware update.
Ricoh pro copier R 80 For Sale Ricoh pro copier for sale. Load a new sheet of paper, then lower the paper release lever. Install the weight roll a and weight joint b according to the width of the roll media. Selects the type setting for roll media.
The media size is detected automatically, therefore no setting for the size is required. Regulations For This Product Do not make any changes or modifications to the equipment unless otherwise specified in the manual.
Page 61 Install the plotteer roll a and weight joint b according to the ploter of the roll media.
Canon W – Colour Printing Series (old) – Canon South Africa
On the W without the stand installed, the paper is feed mm Message Is Displayed Install a new ink tank. Comments to this Manuals Your Name. Set the printhead height adjustment lever to the center position for normal printing. Click the printer in the list you wish to delete, then click the Delete button.
The ink tanks are not installed before shipping, so you must install all the ink tanks before you can use the printer. Page 13 Cleaning the Printer Surfaces Remove the ink tank from the printer, then insert the correct color ink tank. Important z You must install the weight roll to avoid poor performance of the media take-up unit. Print Procedure In the software application, select Print from the File menu. Pull on this lever to unlock the roll media tray so you can draw it out of the printer.
Fold a sheet of plain paper a 2 or 3 times, then insert it from the back of the printer below the lower surface of the paper restraint bthen use the paper to clean. Open the Utilities folder and open Print Center. Printer is not selected as the destination for the print job. You should remove each sheet output to the output stacker, one at a time.
If the printer is set up on the stand, this procedure is not required because the printer automatically retracts the roll media to the standby position. Page 36 Remove the roll holder, remove the holder stopper, then remove the media. Plottrr the Media Take-up Unit, set the take-up mode switch to Auto.